Electroguard A40® Anti Static Paint
Electroguard A40 is a Single Pack Water Based, Static Dissipative Acrylic paint suitable for floors and walls. It is a high specification method of grounding personnel and preventing static build up at an inexpensive price.
Electroguard A40 is a ready to use single pack paint that is extremely easy to apply. A thorough stir of a single tin is all that is necessary before the paint is ready to be used on your floors and walls. The paint can be applied by brush or roller and the equipment may be cleaned after use in warm water.
Electroguard A40 has excellent chemical resistance, can be easily cleaned and is highly durable. The paint has an attractive satin finish and is available in
|Coverage:||10m² per Litre, 50m² per tin, one coat (we recommend 2 coats)|
|Pack Size:||5 litres|
|Drying Time @ 20C:||Touch Dry 2 Hrs
Re-Coat at 8-10 Hrs
Full Cure 3 Days
|Colours:||Light Grey RAL 7035
Blue RAL 5002
Red RAL 3011
Green RAL 6002
Yellow RAL 1023
|Mix Ratio:||Ready Mixed, do not thin|
|Transportation||No transport / hazard issues|
|Typical Thickness:||40 microns per coat, two thin layers. Do not over apply thickness|
|Thinner:||We do NOT recommend thinning this paint|
Two coats are recommended for best results and should be applied over a sound, sealed floor or wall, free from dirt, oil or any loose particles. It is strongly recommended that A40 not be applied over bare surfaces, concrete, wood, tiles, plasterboard etc. Where this occurs a Water Based Primer should be first applied.
We advise against applying if the temperature is below 10°C or if the Moisture Content of the concrete surface to be applied over is greater than 15%. Curing times are dependent on temperature, humidity and ventilation.
Electroguard A40 is water based and has a low odour. A40 is now available with an Anti Slip finish for floors. Please enquire for further details.
Surface Resistance: 10(5)-10(8) Ohms/Square
Resistance to Ground: 10(5)-10(8) Ohms
Conforms to IEC 61340-5-1/2
Charge Decay: Conforms to MILB81705C